The trigger assembly, which includes the trigger, hammer, sear, and trigger body with guard, can be removed by pushing out one retaining pin and pulling downwards on the guard (if a pistol grip is installed, it usually must be removed first as virtually all such grips obstruct the removal of the trigger body). The elevator can be removed by putting the gun on safety and squeezing the sides together, freeing the pivot pins from the receiver. The fore-end can then be moved to the rear, allowing the bolt and bolt carrier to drop out, and then the forend can be removed by moving it forward. The cartridge stop and interrupter will then fall free, leaving just the ejector and the safety in the receiver, held in by screws. The magazine spring and follower may be removed by unscrewing the tube from the receiver (this may be difficult on some new 500s). This level of field stripping is sufficient to allow all components to be cleaned.
We choose the best for you, photos and description to them!
5800 Fulton Ave, Van Nuys, CA 91401, US